ProTek 5164 LiPo Transmitter Battery (7.4V/2800mAh) (MT-4, MT-4S, M11X, M12, M12

Description

New in package
ProTek 5164 LiPo Transmitter Battery (7.4V/2800mAh) (MT-4, MT-4S, M11X, M12, M12S)
This is a ProTek R/C 2S - 7.4 Volt, 2800mAh Li-Poly transmitter battery pack.
This battery has been developed specifically for the Airtronics MT-4, M11X, M12 and
KoProPo EX RR transmitters. This light weight Li-Poly transmitter battery will help to
reduce the overall weight of your transmitter, which is great for long main events!
The overall weight will be significantly reduced when compared to a typical NiMH transmitter
pack as this battery weighs a scant 105 grams! (Six typical NiMH AA batteries weigh
approximately 168 grams). This battery will not only reduce the weight of your transmitter,
you also get an incredible 9 to 10 hours of run time!
How should the battery be inserted into the transmitter?
A suitable foam should be used to pad the battery in the transmitter battery compartment to help
hold the battery in place and prevent it from moving around. Place a piece similar in size to
the battery into the transmitter battery housing under the battery, and then while
pressing lightly on the battery, slide the cover over the battery.
Specifications:
Voltage:
7.4V
Capacity:
2800mah
Chemistry:
Lithium Polymer
Balance Charge Plug:
XH
Charge Rate:
1C
Discharge Plug:
JR/Futaba
Dimension (LxWxH):
99.2 x 31 x 17.9mm
Weight:
105g
IMPORTANT:
1)
DO NOT
leave the battery in your model when charging
2)
DO NOT
leave unattended when charging
3)
ALWAYS
balance charge the battery
4)
ALWAYS
use a LiPo charging bag
5)
YOU MUST
use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
6)
YOU MUST
not over discharge the Li-Poly battery pack
7)
READ & UNDERSTAND
the instructions carefully before operating this battery
Note:
When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge
batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max
capacity of the pack after full charging to ensure a good cycle performance. It is recommended to
fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles.
Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be
lower than 3.2v per cell). Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C
or in a closed car. The high temperature environment could cause damage to the pack or
make it burst. If the battery becomes hot while fast charging, high current discharging or racing,
do not charge the battery until it has cooled completely.
Wait about 20 mins, then inspect prior to recharging.
Free Shipping To USA
Vehicle models vary. We DO NOT guarantee this will fit the vehicle specified in this listing!
Verify that this item is appropriate for your vehicle.  Consult your manual or vehicle manufacturer.
Verify vehicle fit-ment before purchase.
Returns will only be accepted on items that are returned in new, factory-sealed packaging. Used, damaged (unless damaged when it arrived to you), and opened items will not receive a full refund. Any and all warranty claims will be handled through the manufacturer directly.